News
Analysis of Industrial Plug Installation Process
Pubdate: 2022-01-24 10:18:22
Hits: 126
Share :

Analysis of industrial plug installation process;1. Attention must be paid to the installation of the power transmission line of the first industrial plug. The switch power transmission line must be of copper core cross section. When wiring, the standard of "the live zero line enters the power switch and the zero line enters the lamp opening" must be followed, and the leakage protection switch should also be installed in the industrial plug. Embedded socket is embedded in the integrated communication cabinet, which is a power supply device that provides basic DC power for communication and data equipment in the same cabinet. It also has certain versatility. CEE connector CEE standard industrial plug socket is an explosion-proof socket, and the temperature is limited below 32 degrees. IP54, that is, dust prevention is level 5: dust intrusion cannot be completely prevented, but the amount of dust intrusion will not affect the normal operation of the product; Waterproof grade 4: prevent splashing water from invading, and prevent splashing water from all directions from invading.Two ...Figure 3. Then it must be applied to a separate industrial plug. Overload operation will easily cause fire accidents. Three hole socket must be connected to the ground line, and his name can't actually die, otherwise, once it is electrified, it will cause an electric shock accident. Set up multiple control circuits to avoid the short-circuit fault of hemiplegia in the whole house.Figure 4. The industrial socket box frame must be buried out of the frame, and then excavated according to the frame drawing line, with a deep and thin thickness of industrial socket.5. Fix the plastic plate at the bottom of the hole, pass three cables without peeling through the installation box, and then fix the installation box.Figure 6. First, strip off the connection between the zero line head and the socket, then strip off the connection between the zero line head and the socket of the fire line, and finally strip off the connection between the ground line connector and the industrial plug ground line.7. Carefully place the industrial plug in the installation box and fix it, and install it.Frequently asked questions about installing industrial plugs1. In some damp and cold indoor spaces, such as kitchens and bathrooms, it must be installed in the outlet panel splash box or plastic partition to avoid short-circuit faults caused by oil stains and water vapor intrusion.Two ...Figure 3. Suitable transmission line terminals should be used when installing flat-top screw lamps. Long time, exposed part leads to short-circuit fault, short time, loose conductor, excessive contact resistance and over-temperature lead to fire accident.4. Industrial plugs are suitable for power plugs whose cross section is small and the applied output power is too large, which causes the transmission line to burn.